Scarica Buzz & Waldog MMC-3 Hack Rom Hack

Buzz & Waldog MMC-3 Hack Gioco
Consdividi con gli amici:
Parametro Informazioni
Console: NES
Gioco Originale: Buzz & Waldog
Tipologia: Improvement
Genere: Action > Platformer
Modifiche: Other
Ideatore: MottZilla
Data di creazione: 03/02/2008
Ultima modifica: 04/03/2016
Parametro Informazioni
Nome file: BZWDMMC3.zip
Downloads: 14
Requisiti: No Special Requirements
Versione: 1.0
Valutazione:

Descrizione Buzz & Waldog MMC-3 Hack

Don’t think this is gonna be a 100% Gold Remake, it’ll have its differences. Extra battles (some’ll be optionals, tough but rewarding), Hoenn Pokemon (in every area, and hard to find) New areas, Remapped some dungeons (so your old guides wont work) , Extra recurring characters (some’ll hate you, some’ll help you)

Note that the hack is incomplete but feel free to enjoy the hack as-is.

Leggimi Buzz & Waldog MMC-3 Hack

Buzz & Waldog (Prototype) Mapper Hack
By: MottZilla

This patch hacks the Buzz & Waldog prototype so it no longer uses its unique
mapper #156. Instead it uses mapper #118, which is a variation of mapper #4 which
is the Nintendo MMC-3. This was a quick hack and I have not fully tested it. It
shouldn't have any problems but I can't promise you that. Thanks to the NEStopia
source code for mapper register information.

If you want to build a cartridge you must use TKSROM or modify another MMC3
board that supports 128Kb PRGROM, 128Kb CHRROM, and 8Kb WRAM (aka PRGRAM). You
must modify it to 1-screen mirroring. I'm not sure how to do this yet. Games
which 'might' use TKSROM are: NES Play Action Football, Pro Sport Hockey.

If you wish to use this on the PowerPAK or an emulator that doesn't support the
mapper 156 just patch and play. Some emulators might not recognize mapper 118
though but modern ones and the PowerPAK do recognize it. 

ALSO INCLUDED:
Lives.ips

This disables the "infinite lives" from the prototype. Might
wanna use it if you build a cartridge.

Cartridge Info from Bunnboy:
To make a TKROM into TKSROM you just need to rewire CIRAM A10. 
Cut the CIRAM A10 wire that connects the mmc3 pin 10 to nes connector pin 22. 
Then solder a wire from nes connector pin 22 to mmc3 pin 12 (chr a17). 
You may have to cut the chr a17 trace that goes to the chr rom, 
but it should be unused on the 128KB chip anyways. 


Original ROM will refect this data:
Buzz and Waldog (U) (Prototype) [!].zip
PRG-ROM:     128k, CRC: 0xA84BF160
CHR-ROM:     128k, CRC: 0xEBC83877


Patched ROM will reflect this data:
Buzz & Waldog (U) [MMC3] [!].nes
PRG-ROM:     128k, CRC: 0x67D1B13B
CHR-ROM:     128k, CRC: 0xEBC83877